Stupendo finale dynaco st150 75 w rms su 8 ohm vedi specifiche perfetto e stato ricappato e ricablato per tanti anni ancora godrete del suo suono coinvolgente e caldo
. Specifications
Power output: 75 watts per channel into 8? (stereo)
Frequency response: 20Hz to 20kHz
Total harmonic distortion: 0.25%
Damping factor: 50
Input sensitivity: 1V
Signal to noise ratio: 95dB
Speaker load impedance: 4? to 16?
Semiconductors: 24 x transistors, 2 x zener diodes, 16 x diodes, 2 x thermal sensors
Dimensions: 14.5 x 13.75 x 7 inches
Weight: 29lbs
Description
The Dynaco Stereo 150 is a two channel power amplifier employing all silicon semiconductors.
They include 24 transistors, 2 zener diodes, 16 diodes, and 2 thermal sensors. The output circuitry is of the full complementary symmetry design. The entire amplifier, except for an input network, is direct coupled.
It's measured distortion levels approach the threshold of much laboratory test equipment, not only at the commonly specified full power ratings, but more importantly at very low power outputs as well.
This is the result of circuit techniques which eliminate any discernible crossover notch at low levels, and contributes to the Stereo 150's freedom from listening fatigue.
It's accurate, uncoloured sonics have been achieved on a wide variety of loudspeaker loads, including electrostatics and multiple drivers with complex crossovers.
The design of a very fine power amplifier implies the necessity of several protection techniques for the amplifier, and for the speaker load. In addition to the AC line fuse, four separate B+ fuses are supplied.
Electronic volt-amp limiting ensures safe operation of the output transistors, and a thermal sensor mounted directly on each output stage reduces the input if high temperature
Indicaci il motivo per cui vuoi segnalare questo annuncio:
Grazie per averci aiutato a far rispettare le regole di pubblicazione degli Messaggio.